Slash_4X4

All Products proudly made in the U.S.A.

REM Slash 4X4 Front Suspension Arms

Made from Billet 6061-T6 Aluminum for strength
and light weight.

Perfect fit with stock or after-market parts

Stock Length

All hardware included for installation including
stainless steel hinge pins and retaining rings.

weighs only 1.4 oz per arm

Requires drilling through the Hinge pin hole to
allow an E-Clip to be used on the other side.

(As Shown)

REM 1081 $24.00

REM Slash 4X4 Rear Suspension Arms

Made from Billet 6061-T6 Aluminum for strength
and light weight.

Perfect fit with stock or after-market parts

Stock Length

All hardware included for installation including
stainless steel hinge pins and retaining rings.

Allows the use of Traxxas Sway Bar Kit

weighs only 1.4 oz per arm

REM 1082 $24.00

REM-1120 Rear Bearing Carriers

An additional hole was added to give more clearance for
the drive shaft when the suspension is at "full droop"
(as pictured)

Low-Center-Of-Gravity Design allows you to lower your
truck an addition 5 mm over stock

Made from Billet 6061-T6 Aluminum for
strength and light weight.

Perfect fit with stock or after-market parts

Weight 0.4 oz/pair